Repository logo
 

Research Publications (Engineering and Built Environment)

Permanent URI for this collectionhttp://ir-dev.dut.ac.za/handle/10321/215

Browse

Subject: search.filters.subject.Membrane technology

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Treatment of water and wastewater for reuse and energy generation-emerging technologies
    (IntechOpen, 2019-04-25) Tetteh, Emmanuel Kweinor; Rathilal, Sudesh; Chetty, Maggie; Armah, Edward Kwaku; Asante-Sackey, Dennis
    Fresh water quality and supply, particularly for domestic and industrial purposes, are deteriorating with contamination threats on water resources. Multiple technologies in the conventional wastewater treatment (WWT) settings have been adopted to purify water to a desirable quality. However, the design and selection of a suitable cost-effective treatment scheme for a catchment area are essential and have many considerations including land availability, energy, effluent quality and operational simplicity. Three emerging technologies are discussed, including anaerobic digestion, advanced oxidation processes (AOPs) and membrane technology, which holds great promise to provide integrational alternatives for manifold WWT process and distribution systems to mitigate contaminants and meet acceptable limitations. The main applications, basic principles, merits and demerits of the aforementioned technologies are addressed in relation to their current limitations and future research needs in terms of renewable energy. Hence, the advancement in manufacturing industry along with WWT blueprints will enhance the application of these technologies for the sustainable management and conservation of water
  • Thumbnail Image
    Item
    Reclamation of end-of-pipe textile effluent using low energy membrane systems
    (South African Institution of Chemical Engineers, 2015) Xaba, P; Rathilal, Sudesh; Pillay, L.
    In this study, the reclamation of end-of-pipe textile effluent originating from a reactive dyeing textile mill was investigated using low energy membrane based processes. Effluent quality, salt recovery and membrane recovery were the main parameters used to evaluate the membrane process. Flat sheets of the SR90 and NF90 Dow FilmTech nanofiltration (NF) membranes were used on a pilot scale membrane system. The UF multipore membrane was used in the pretreatment runs. The quality of reclaimed water was measured against the specified water quality in terms of the internal criteria for effluent recycle (ICFER) provided by the mill. It was required to optimize the SR90 and NF90 membrane performances so as to set operating parameters for pilot study. The average critical flux for the SR90 membrane was found to be ±31 LMH at 5 bar TMP when directly feeding the effluent without any pretreatment. The average critical flux for the NF90 membrane was found to be approximately ±15 LMH at 10 bar TMP when no pretreatment was used. All rejections were found to be >90% for all specified parameters as per Table 1. The quality results from the SR90 and NF90 membranes with pretreatment showed that the permeate could be recycled and reused in the dying processes within the mill. It was however concluded that the NF90 membrane produces high quality effluent as compared to the SR90. It was of importance to determine if the SR90 and NF90 membranes could be recovered and reused after directly feeding un-pretreated feed effluent. The flux recoveries on the SR90 and NF90 membranes were 84.72% and 82.17%, respectively after chemical cleaning. It was further concluded that the salt initially fed in the dying process could be recovered from the waste stream especially when using the SR90 membrane for reuse. However, the colour parameter was found to be slightly out of specification when using the SR90 membrane. To improve the colour of effluent produced when using the SR90, it was recommended that a granular activated carbon filter needs to be employed downstream of the process to polish the effluent.